Is brake line flaring difficult?

[Paisano]

Cool. Thanks for all the information. Need to practice some more on flaring. I'll follow up

 

[racsan]

what size line?


the titan is the best one for the money.

Titan Tools Double Flaring Brake Line Tools, 45 Degree 1/4 & 3/16 | eBay

It makes SAE Double Flares, For use on steel, nickel, and copper tube, Designed to be used in the tightest of areas to repair a brake line, Handle can be removed and the head of the tool can be mounted in a bench vise so you can make several flares with ease, The handle can be removed.

www.ebay.com

great deal...

Pardon Our Interruption

I got one of those from jegs when I redid my F150 lines. worked really well.

 

[Paisano]

Cool. Thanks for all the information. Need to practice some more on flaring. I'll follow up

Just recently started practicing with the Auto Zone loaner tool.
My flares look good. But occasionally, flare is not perfect 90 degree to the tubing. A little more practice and I should be good to go.
I will follow up when done

 

[Paisano]

Someone suggested learning brake line flaring might even be fun. I agree. I think it's cool

 

[Shran]

I had one flaring tool that would make a crooked flare every time, no matter what I did. Looking back I think it was the little button piece that you use in the first step. I remember it being a very loose fit so if it wasn't perfectly centered, the tube would crush unevenly. I have a better one now and it works great 95% of the time.

Main thing regardless of what tool you use is to file the tube perfectly flat and square after cutting it and then debur the inside. I use a dull pocket knife for that.

 

[Paisano]

Makes sense Shran.
I have to make do with lower quality AZ loaner tool. I'm still able to turn out some good flares with it.
I'll practice some more tonight and I'll send you guys a pic of a flare

 

[Paisano]

I practiced brake line flaring again tonight. I decided not to post a pic yet because....well.....to be honest, my flares just aren't up to snuff yet. The flare still is still a bit crooked and not good 90 degrees offset from tube.

I made a few observations in areas that I think are holding me back.

1. I was using one of those mini tubing cutters. The little cutting wheel cuts at a slant.
I am switching to a better quality small pipe cutter I have in my tool cabinet.

2. When you crank down the yoke from the flaring kit, the tapered point wobbles when it presses into the brake line tube
I mean the thing really has significant play. And it is a brand new kit. I am the first user. So I'll hold the tapered point in place
while I crank the yoke.

3. I am cutting small lengths of practice tubing from a 25 foot roll of coiled brake line. So it already has some curve bent in. What is the best way to straighten out rolled pliable poly steel brake line.......with hand tool ?