Idaho prerunner project

[rangerdanger208]

I need to find a bigger spare haha

 

[rangerdanger208]

 

[rangerdanger208]

flipped down. i plan to start building the ramp on the backside for a dirt bike

 

[alwaysFlOoReD]

Looks good so far.
Back when you put the f-150 spring in you say you only got 1/2" of lift yet your camber looks wack. Was that pic taken before moving the truck to let the suspension settle? What did the spring come out of? I want to up the spring rate on my race truck without changing the height so any info would help. Thanks,

Richard

 

[rangerdanger208]

 

[rangerdanger208]

out at the pits!!

 

[alwaysFlOoReD]

Just saw your bumper and tire hanger, good job, I like the design and the ramp idea.

Richard

 

[rangerdanger208]

got started on a light bar. should hold 6'' lights. I used 1'' pipe

 

[rangerdanger208]

this isn't exactly where it is going to sit. I want the bottom of it right in front of the weather strip on the windshield.

 

[rangerdanger208]

thoughts? any advise on mounting??

 

[rangerdanger208]

33s bitches!!!

 

[rangerdanger208]

 

[rangerdanger208]

Looks good so far.
Back when you put the f-150 spring in you say you only got 1/2" of lift yet your camber looks wack. Was that pic taken before moving the truck to let the suspension settle? What did the spring come out of? I want to up the spring rate on my race truck without changing the height so any info would help. Thanks,

Richard

the springs were out of a 89 f150. I did not see the actual truck so I don't know if it was a4x4 or not. im guessing it was a beat up truck or 2wd to sag a ranger that bad haha. I like the rough countrys though. a little stiffer than the stock coils

 

[rangerdanger208]

it sat like that because I had 4'' drop brackets

 

[rangerdanger208]

Get-r-done. I have family in Rathdrum ID.

is that north Idaho? I am in south east idaho