I am NEVER Wheeling AGAIN.......

[89PBR96]

well things keep getting worse , i think i actually bent the frame

NONONONONO I hope not man

 

[ozziemo27]

why do you think that?

 

[WNY964x4]

why do you think that?

because even whn i adjust the driver side inner tie rod in all the wy it is still about an inch too long , and i have yet so see if i can adjust the passenger side enought to bring the toe back in , it would make sense that if whenb they used that front weird crossmember triangle shaped thing to pull me through a mud hole that when it pulled the center of that forward , it pulled the frame rails in , which would pull the axles in and push the wheels out , or i just really screwed up all my brand new steering components , which i highly doubt

 

[huntin_muddin_91]

BUILD... BREAK... repeat...
Aint fun unless u gotta trailer her home. I feel ur pain tho

 

[kris97ranger]

gotta get some proper tow points up front. so what ur saying is the frame rails are like /\ ? the top being the front of the truck. if so can u get a high lift and spread them back out
________
Prilosec Lawsuit Info

 

[WNY964x4]

gotta get some proper tow points up front. so what ur saying is the frame rails are like /\ ? the top being the front of the truck. if so can u get a high lift and spread them back out

that is what i am thinking , but now i have some numbers to go by

EDIT: i just went out and measured the front end and it is still perfect

 

[bcost882]

well it is always 1step up .5 step back what can you do. atleast you are making headway

 

[WNY964x4]

well i still have to figure out what is throwing the steering off

 

[WNY964x4]

home made bumper straightening

 

[89PBR96]

^ lol I did that to a few rides of mine before whatever works right mine finally broke and I need to straighten my rear bumper

 

[WNY964x4]

well i got my steering linkage all straightened out , it was a bent component , i blew a brake line , and in doing that i completely screwed up and now have to run a line from the MC to the left front Junction Block , from there to the RF wheel , and one from the MC to the Junction on the grame for the rear

 

[Boggin]

your doing good work man

 

[WNY964x4]

your doing good work man

i am trying my best , i should have her finished tomorrow

 

[Boggin]

sweet. then get that 4bt haha

 

[WNY964x4]

sweet. then get that 4bt haha

yea , that 4BT is on hold until i get my 2000 done , and that is gonna be the end of the summer probably , i have 3 projects ahead of it , well actually i have 3 of my family's vehicles first , i have the 2000 and 2003 cadillac's i have to switch the front seats in , the 1976 Corvette i have to fix the brakes on and replace the U-Joints in , and the 72 Chevy Pickup i have to do a tranny swap in , then i get to put the drivetrain in the 2000