Hydraulic clutch on 2003 ranger 2.3L 4 cylinder

[bassman1488]

Ho to bled or adjust/ fix


Sent from my iPhone using Tapatalk

 

[Mark_88]

Welcome to TRS~!

There is a bleed screw on the slave outlet that will allow you to bleed the clutch...crack it open and attach a line...keep the reservoir topped up...

Are you installing new parts or is the pedal too hard?

 

[discosucks]

If it's anything like my 97 then it'll be easiest to remove the whole hydraulic system and stretch it out to bleed it because the slave is at a bad angle and collects air. Not too bad of a job though. There's YouTube videos if you're not familiar ..

 

[prerunner]

You have to bench bleed the hydraulic system before you install it. This tutorial will show you how: http://therangerstation.com/forums/showthread.php?t=109088