atomicjoe23
Well-Known Member
- Joined
- Oct 3, 2008
- Messages
- 122
- Vehicle Year
- 1979
- Transmission
- Automatic
Can anyone help me wiring some '00 Mercury Mountaineer power seats into a '99 Ranger. . .
. . .the Mountaineer seats have 6 wires coming out of the Mercury wiring harness (I kept it), here are the 6 wires out of the two quick disconnects on the passenger seat:
Yellow quick disconnect (I think this is for the airbag sensor for the Mountaineer, if so unnecessary in my truck) has two wires coming out of it:
-yellow with white stripe
-brown with yellow stripe
Black quick disconnect (I think this is what actually controls the power functions of the seat) has four wires coming out of it:
-light blue with white stripe
-black with white stripe
-gray with yellow stripe
-black (ground)
I have not installed the driver's seat because I want to make sure I know how to wire it and be able to adjust the seat before I install it. There are three quick disconnect harness on the driver's seat.
Yellow quick disconnect (once again I think this is the airbag sensor) has two wires coming out of it:
-white with light blue stripe
-brown with light blue stripe
Black quick disconnect (power for control functions) has four wires coming out of it:
-black with white stripe
-gray with yellow stripe
-light blue with white stripe
-black (ground?)
Gray quick disconnect (seat belt sensor???) has two wires coming out of it:
-brown with light blue stripe
-black (ground?)
If I knew what these wires were I could get this wired up
Thanks for the help!
. . .the Mountaineer seats have 6 wires coming out of the Mercury wiring harness (I kept it), here are the 6 wires out of the two quick disconnects on the passenger seat:
Yellow quick disconnect (I think this is for the airbag sensor for the Mountaineer, if so unnecessary in my truck) has two wires coming out of it:
-yellow with white stripe
-brown with yellow stripe
Black quick disconnect (I think this is what actually controls the power functions of the seat) has four wires coming out of it:
-light blue with white stripe
-black with white stripe
-gray with yellow stripe
-black (ground)
I have not installed the driver's seat because I want to make sure I know how to wire it and be able to adjust the seat before I install it. There are three quick disconnect harness on the driver's seat.
Yellow quick disconnect (once again I think this is the airbag sensor) has two wires coming out of it:
-white with light blue stripe
-brown with light blue stripe
Black quick disconnect (power for control functions) has four wires coming out of it:
-black with white stripe
-gray with yellow stripe
-light blue with white stripe
-black (ground?)
Gray quick disconnect (seat belt sensor???) has two wires coming out of it:
-brown with light blue stripe
-black (ground?)
If I knew what these wires were I could get this wired up
Thanks for the help!