fullsize SAS and 9" swap. pics

[leonardwoolsey]

i bet with all the parts still attached to the axle dont help either. i have to put a body lift on my ranger. a 2" when i do the motor swap.
351w

 

[leonardwoolsey]

Help with axle seals

the 9" axle shafts have the seals on them.(pictured) someone please tell me the trick to taking this off so i can replace the bearing and seal. also what are the names of the seals in the dana 44. there is a hub seal, and i believe another seal that goes on the inner axle shaft and seals the axle tube?

 

[GOODOLEBOY84]

well there are several ways, one you can do it right and press the bearings off with a press, or you can cut the collar and bearing just dont cut the axle,
moser makes some really nice bearings for the 9" inch they have a oring seal on the outside of the bearing, they dont leak at all, they cost around 70 buck for the set you can get them at summit

 

[leonardwoolsey]

what about putting them back on? will i need a press or something and is there a certain depth it has to be at or length?

 

[4x4builder1]

check out this link before you put the brakes back on I always ditch the drum brakes and its cheaper then you might think http://diy4x.com/brakes.htm