Full size transfer cases

[dangerranger83]

Here's my np208 in my ranger. It sits behind an np435.

I used the original ranger trans cross member but missed it a little too work for now but I have to make another one so that I can put a front drive shaft on.


Sent from my A500 using Tapatalk 2

 

[BigBronco2]

Ok, so I'm building my bronco 2 right now and Im looking at the same problem with the frame clearance. You guys are saying that the 1356 will fit without too extensive cutting?
I have the tranny pretty much centered and it just dont look like its gonna go. I was going to notch a hole in the frame and build a box to reinforce it so it dont get weak while wheeling.
What do you guys think?

 

[Rowdy Fitzgerald]

Why notch the frame? Pull the lines, wires out of the way and heat it up with a torch then bend the frame enough to clear the T-case. I know heating the frame isn't great for it but neither is notching it.

 

[simonsays]

Why notch the frame? Pull the lines, wires out of the way and heat it up with a torch then bend the frame enough to clear the T-case. I know heating the frame isn't great for it but neither is notching it.

That is how I did mine.


Sent from my EVO using Tapatalk 2