Hey guys im looking to lower my 93 ranger 4.0 stepside for as cheap as possible can anyone help me out? Also is it possible to put a cold air intake in it? Thanks a lot
Well, they lied... Ford gave you a cold air intake from the factory (it's not all shiny with one of them crappy cone filters) but it is cold air (comes from in front of the radiator)... A K&N intake doesn't do anything except let in more dirt and make noises...
Again - do you want a 3/4, a 4/6, a 5/7 or do you want to lay frame or rockers? It all depends on HOW FAR you want to go. A 3/4 will be the cheapest if you do it right - Beams up front and axle flip in rear - under $400 unless you can get the beams from a friend or something. Flip kit is super cheap - $50 or less.
Brownie-Hazmat's V-6 is running @ 92rpm Edit: Cold air Intake? A black-top road on a summer day down here gets about 168*F. "Cold Air Intake" kinda falls in the same category as-ahh-hmmm-"Sun-rise". Now, if they called it a "not quite as hot" air intake, I'd buy one--'cept i already got one,too.
It seemed like the logical thing to do at 3:30am. The good news is that i could stay focused for 1 minute. the bad news is--I noticed you didn't give Brownie any of my chop-shop tips for doing a 3/five drop for under $79.95 P.S. Brownie--don't even ask--go w/what Hazmat says
For
a small yearly donation, you can support this forum and receive a 'Supporting
Member' banner, or become a 'Supporting Vendor' and promote your products here.
Click the banner to find out how.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.