- Joined
- Apr 22, 2014
- Messages
- 46
- City
- Albuquerque, NM
- Vehicle Year
- 1988
- Transmission
- Manual
- Total Lift
- 4 Sus+3 Body
- Tire Size
- 35s
Parting out my truck.
Selling my dana 35 air locker. It’s a yukon zip locker part number YZLM35-4-27.
This is for the dana 35 with 3.54 and numerically higher gears, and 27 spline shafts. For example I ran this in my dana 35 TTB with 3.55 gears. I ran this while also running the c clip eliminator mod as described here:
This is a used part that works perfectly. Also, notice in the pictures that yukon welds the cap to the locker body? Weird right? Yeah that’s what I thought too, but this is how the dana 35 lockers come from them. I guess they are trying to make them as strong as possible for the jeep guys that try to run these in the rear with 37s? I’m not sure, but if you buy it, I didn’t want you to be surprised like I was.
I only have what is pictured. You’ll need carrier shims and what not to get it setup in your diff. The bearings seem fine to me.
https://www.yukongear.com/shop/yzlm35-4-27
$350 shipped to the lower 48.
Selling my dana 35 air locker. It’s a yukon zip locker part number YZLM35-4-27.
This is for the dana 35 with 3.54 and numerically higher gears, and 27 spline shafts. For example I ran this in my dana 35 TTB with 3.55 gears. I ran this while also running the c clip eliminator mod as described here:

Dana 35 / 28 C-Clip Eliminator - The Ranger Station
Submitted By KTRANGER Note: the purpose here is to eliminate the need to pull off the drivers side tire, spindle, axle and the entire Dana 28 / Dana 35 carrier from the vehicle. This must be done with the … Continued
www.therangerstation.com
This is a used part that works perfectly. Also, notice in the pictures that yukon welds the cap to the locker body? Weird right? Yeah that’s what I thought too, but this is how the dana 35 lockers come from them. I guess they are trying to make them as strong as possible for the jeep guys that try to run these in the rear with 37s? I’m not sure, but if you buy it, I didn’t want you to be surprised like I was.
I only have what is pictured. You’ll need carrier shims and what not to get it setup in your diff. The bearings seem fine to me.
https://www.yukongear.com/shop/yzlm35-4-27
$350 shipped to the lower 48.
Last edited by a moderator: