Clutch won't disengage

[Rockwell]

I have a 2005 Ford Ranger 3.0 V6 two wheel drive that has a problem where the clutch won't disengage all the way. The pedal will go till there is about an inch and a half til the floor with no resistance. I've bled the system multiple times and just barely replaced the master and slave cylinders with no change in its condition. Any ideas.

 

[black_demon69]

I would say that there is air in the master still. It needs to be flipped so that end with lines is higher and then it should bleed.

 

[Mike92STX]

Another idea is check the bushing were the master cylinder is connected to the clutch pedal arm. I had mine go bad and thought the clutch needed bleeding. after trying to bleed it I checked the bushing and it was damaged. got a new one and replaced it works fine now. I had replaced it shortly after I got the truck but it was doing the same thing a week after replacing the bushing so that's when I tried bleeding it 4 or 5 times.