• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

clutch wont bleed properly


I have tried it 100 different ways. That is still my favorite.

FWIW I too have hardware store parts holding my MC to the firewall.


I just want to say that despite all my whining, I am glad I found this board. Because I hung here before I did the job , I found out about the PITA I was facing . I attempted to remove the MC with the transmission. That led to having to drill beside the screw in the loose nut to relieve it I used a 2 foot long 1/4 inch bell hanger's bit. The MC was beyond saving at this point. I put the truck in a 12x20 tent on New Years "12 and didn't drive it out until April 21st. Even the hub repair, I just finished up took me 3 hours,. :D
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top