• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Clutch/Slave installed backed up stalled out now wont start.. HELP


lumbee

Member
Joined
Dec 15, 2009
Messages
17
Vehicle Year
1995
Transmission
Manual
Original project started here http://www.therangerstation.com/forums/showthread.php?t=146970

I have clutch and slave cylinder installed everything bolted up. Now i dropped truck off jack stands removed jack/stands re hooked battery up, got in truck it fired right up put in reverse everything was going great. I then put in first started to pull forward and stalled out.. Now it will not start ive checked coils, got gas and still not luck.. I hear fuel pump come on and prime so i dont think thats a issue but when i press the fuel pressure at the fuel rail the gas barely came out.. any suggestions please help.
 
When you say you checked the coils, you checked for spark? also you can try cycling the key several times to prime it then try cranking it, could be your pump is on its last legs, and it just choose this time to show up, or you may have a problem with fuel drain back, so not holding pressure, 99 doesnt have a return line
 
update.... it was the fuel filter..
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top