Welcome Visitor! Please take a few seconds and 
- Joined
- Aug 15, 2019
- Messages
- 4,004
- City
- Oklahoma
- Vehicle Year
- 1993
- Engine
- 4.0 V6
- Transmission
- Manual
I cut a circle type gasket using a snap on dip type lid.
Tacked the lid halfway on, halfway off a work bench
Used an exacto knife on the outer mark and pulled it (the lid) in a full circle
Then put the knife on the inside mark and pulled it in another full circle
Came out fairly well actually
Tacked the lid halfway on, halfway off a work bench
Used an exacto knife on the outer mark and pulled it (the lid) in a full circle
Then put the knife on the inside mark and pulled it in another full circle
Came out fairly well actually
Last edited:
