98 - 6in drop problem

[dropt98]

Ok ive already installed a 3 inch drop all the way around (3 inch coils and leafs) ... then i went and put a 3 inch flip on the rear so now its at a 6 in the back and 3 in the front.... ok so... i went to buy some djm drop control arms and they say that it wont work with my 3 inch bell tech drop springs (because of rubbing) in the front and ill have to buy uppers lowers and 2 inch coils but that will only be 4 inches..... so i guess my question is is there any way to lower the front 6? and still be able to align the front.... or should i just spent the bout 500 on new control arms and just deal with the 4/6

 

[ES894x4]

your gonna need to run the uppers and lowers if you want to run your belltech coils but thats only 5" of front drop and people say thats usually maxing your alignment abilitys to get it right. why dont you get a tape measure and see if it wont work

 

[slammedxonair]

I have a few customers that run the DJM arms with the Belltech 3" coils. The coils do pretty much max out the alignment eccentrics. You could also put the rear at a 5" drop if you use the stock leaf springs and just the axle flip kit as well if you are trying to raise the back at all.