- Joined
- Aug 28, 2024
- Messages
- 74
- Points
- 101
- Age
- 47
- City
- Matagorda
- State - Country
- TX - USA
- Vehicle Year
- 1996
- Vehicle
- Ford Ranger
- Drive
- 2WD
- Engine
- 2.3 (4 Cylinder)
- Transmission
- Manual
- My credo
- If you expect the worst and hope for the best, you're already planning for failure.
So the other day while doing fog light install and removing a bunch of old wiring from an old stereo system (from before I owned it) I was doing a bit inspecting for future projects and found that when they put the seats in, they didn't bolt them down, they welded them in place. Now I'm in search of new front floor pans and am coming up with almost no good results. I have found pans for earlier models (first gen) and for even newer (third gen and up), just nothing exact for my year (1996 ext cab). I mean, I could just cut out at the point of the welds and try patch panels, but I would prefer to replace the whole pan for uniformity. Any one know of a good resource?
