• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

84 with a 7ft bed. Help with driveshaft and 4.2L V6 manual transmission mounts and clutch


MadMax_636

Well-Known Member
Joined
Nov 7, 2019
Messages
547
Age
30
City
Georgia
Vehicle Year
1984
Engine
2.8 V6
Transmission
Manual
Total Lift
However much it goes up when I get my fat ass out.
Total Drop
How much it goes down when my fat ass gets in.
Tire Size
Dry rot and old
As the title states. Im stuck in the part picking phase. I dont know what transmission mounts, driveshaft, and clutch I need to get. Since the transmission is for a 4.2L v6 but going onto a 302. Im assuming the bell housing is smaller so id need a smaller flywheel. Also what starter would/should I use. Could I use the starter from the 2.8?
 
Check out 'Advance Adapters' on the internet. They should have what you're looking for, at least some of the parts. They also have an interchange list. Other than that, Check out the Tech Library on this site. I hope this helps you out, at least a little.
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top