2011 Fuel Tank pressure Sensor location

[Dmichels]

2011 Ranger 4.0 liter
I am have 2 codes P0452 and P0454. I need to know the location of the FTP sensor so I can check the wiring. The voltage of the sensor is all over the place on my scan tool so I am thinking bad wires. Anybody have any experience with chasing this problem down
Thanks Dave

 

[franklin2]

I have never messed with this before, but I am getting hints that it's part of the sending unit on the tank from this picture. I will attach the picture and the key to the numerical descriptions is below.

1	9002	Fuel tank
2	9057	Rear fuel tank support strap
3	W506435	Fuel tank support strap bolt (2 required)
4	9A147	Fuel tank skid plate (if equipped)
5	W520112	Fuel tank skid plate nuts (if equipped) (4 required)
6	9054	Front fuel tank support strap
7	—	Rear fuel tank vapor tube and Fuel Tank Pressure (FTP) sensor assembly-to-fuel pump quick connect coupling (part of 9G291)
8	—	Fuel tank filler pipe hose-to-fuel tank clamp (part of 9034)
9	—	Fuel tank filler pipe (part of 9034)
10	—	Fuel supply tube-to-Fuel Pump (FP) quick connect coupling (part of 9G291)
11	—	Fuel tank filler pipe vapor tube-to- FP quick connect coupling (part of 9034)
12	—	Fuel return tube-to- FP quick connect coupling (part of 9G291)
13	—	FP electrical connector
14	—	Rear fuel tank vapor tube and FTP sensor assembly-to-fuel tank vent valve quick connect coupling (part of 9G291)

 

[Dmichels]

Thanks for the diagram I think the sensor is in line on line #7 just trying to figure out where to look for it