2.9l intake manifold swap

[bobbywalter]

You would need to fab an adaptor elbow if you wanna put it in place of the TB like bobby suggested

or just cap it and cut the top of the manifold.



pull butterfly and clamp a 90 on....cut a flang adapter and make a gasket....

Rubber Elbow, RE90-225

Rubber Elbow 2.25" - 90°

fuelsafe.com

Amazon.com

https://www.oreillyauto.com/detail/c/nickson/exhaust/adapters---reducers/inlet-flange-adapters/d8fa18e998f5/nickson-exhaust-adapter/nic0/544313/v/a/17991/automotive-car-2004-nissan-350z?pos=3

i probably have enough crap laying around to just try it if so inclined .... with a few clamps and some gasket material....











or fab up something with the plas and welder... not that you would have to. you can cut the top off and make your own base plate and bolt it together.


it would run.... not efficiently but i am confident it will work. hack for sure.......just easier then trying to hack up a Siamese port intake for crap results.

 

[fxkl47BF]

you are not too old for megasquirt.

electronic felgercarb

off topic, i noticed your signature
my daily driver is a 86 f250 6.9l diesel mostly all stock
now that's fuel injection

i long for my younger days when i put a 283 in a 1/2 ton 57 chevy pickup
put power to the distributor and starter and you're good to go

 

[bobbywalter]

electronic felgercarb

off topic, i noticed your signature
my daily driver is a 86 f250 6.9l diesel mostly all stock
now that's fuel injection

i long for my younger days when i put a 283 in a 1/2 ton 57 chevy pickup
put power to the distributor and starter and you're good to go

yup....that is exactly how my truck works. for now anyway. may be all mechanical at some point.