1983rangerv8
Member
- Joined
- Oct 5, 2013
- Messages
- 8
- Vehicle Year
- 1983
- Transmission
- Automatic
Hello im doing a swap on my ranger need some help on the pin outs on these clips so i know wich ones to wire to my mustang harness.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
1983 ranger 5.0
- Thread starter 1983rangerv8
- Start date
what mustang harness you have? that truck is wired for carb and duraspark ignition. that 8 pin plug in the pic has a wire for oil pressure sensor, coolant, and a keyswitched 12v, not sure about the others, or in which order, best to just back trace it to were they were on the old motor. is the engine your swapping to EFI?
1983rangerv8
Member
- Joined
- Oct 5, 2013
- Messages
- 8
- Vehicle Year
- 1983
- Transmission
- Automatic
I am using a 1986 mustang and yes its efi i know its possible theres a write up on a 1984 bronco in the tech article's.. but doesnt really tell you what wires he used from the body harness.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Latest posts
-
-
-
-
-
-
-
Wanted: Coil Spring Measurements When Installed (Stock & Lifted)
- Latest: Marcos_Rngr
-
-
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
