• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

1966 ford 200 in a 1988 ranger?


Blackdog455

Well-Known Member
Joined
Aug 15, 2008
Messages
291
City
Maple Valley, WA
Vehicle Year
1988
Transmission
Manual
I just looked through a couple threads on the subject but I have a few questions. I have the i6 200 with an auto c4. Will it hook up to the rear end I currently have? I currently have a 2.3 4x4, manual ranger. The c4 is 2x4. What about engine mounts? What elaw should I look out for?

Should it be a pretty simple swap? Thanks guys!
 
I doubt there will be anything simple about, but if it fits under the hood it shouldn't be too bad.

Take LOTS of pictures and describe everything.
 
There might be enough room if you remove the fan and put a electric fan in front of the radiator. You will also need to have a driveshaft built to fit also. Your better of going with a 302 and a C-4 and is still alot of custom hammering. The six banger is just too long.
 
Hmm...I am only considering putting it in cause I have a 200 and c4 available. Not, going to go out and find a 302. Would the 200 work with the manual tranny I already have in it? I'm guessing no...
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top