coolant

this small thing is leaking coolant, it’s on the back left side of the engine, I have a 4.L engine although a similar thing exists on my 3.L please let me know if you have any clue on what it is or what it does. Thank yall

I'm trying to take out the radiator on my 1983 2.8l v6 ranger to give it a good clean and was taking off the top oil cooler line. I initially twisted the nut not thinking that the line was still connected and was going to twist. I twisted it a bit and then stopped, I then tried to undo the nut...

Hello everyone , I need some help , today I was replacing the temperature sender on my 94 b3000, however I have know cracked the area where the sender goes into , anyone know the name of the part that is cracked? I’ve been trying to find it but no luck , I’m looking to replace it then to try to...

So it is a 4.0l 2003. Leak is about 1 drop every second while running and coming from the passenger side. I got the Pittsburgh pressure leak tester and it worked about as good as anything else from my boys over at Harbor Freight which is to say the cap wouldn't fit because of a defect. Knowing...

Original Poster: Dave18 Difficulty: 5 out of 10 Time to install: 8 hours Disclaimer: The Ranger Station.com, The Ranger Station.com Staff, nor the original poster are responsible for you doing this modification to your vehicle. By doing this modification and following this how-to you, the...

This is what my coolant gauge is doing. It never heats up to what it was before. Have lots of heat coming out of the vents when I turn it on. It does have a “new” radiator from a newer 2.3 Lima. an answer on this post or a link to another post works for me 93 2.3 regular cab

Hello guys new to the forum, before I did a head gasket job I leak tested all my cylinders got to the last cylinder #3 and seen that I had bubbles in my radiator so now I have just completed a head gasket job, and rechecked with the leakdown test no bubbles on any cylinder and also did the...

Hey all, I have a 2002 Ranger with the 3.0L engine. The lower radiator hose was leaking at the tee, and so I replaced it. I used a Gates hose and used worm clamps instead of the spring clamps. I tightened all of the worm clamps with a screwdriver. I'm now getting a leak where the hose connects...

I’m changing out my radiator today and have a question about how to seal the trans cooler lines. Do I need to use any sort of thread sealer or just tighten it until it doesn’t leak? Any other hints about bleeding air out would be welcome too. Thanks in advance, John

I have a 96 ranger with a 2.3l. It had the cluster with no tachometer and I swapped it for one that came out of a 95. Everything is working but the coolant temp gauge. It worked in the other cluster perfect. I ended up taking both all the way apart to take out the gauge it self and swap them. It...

Noticed some antifreeze under my 96 2.3 today and noticed a very consistent flow of coolant coming from the passenger side of the head where it meets the block. I’m guessing this means the head gasket is blown but I don’t see any water in oil, the truck has not overheated since I have owned it...

I have a 1995 Ford Ranger, 2.3L from Florida. The truck runs great, but I moved to Ohio last fall where it's a big colder. Before the truck came here the heating had never been used. So last year the heat didn't work and I did a bunch of diagnostics on it to get it working. Last year I...

I pulled my motor because I was leaking coolant out of the back of the motor from somewhere I couldn’t see with the block in the truck. Oil was normal, coolant was coolant, when the block was out I noticed it looked like it was seeping out of the corner of the head gasket so I pulled the head...

Not sure if the old signature I made a couple years ago will show, so I'll start with the specs. 2000 Ranger 2.5L I4 Lima Engine I replaced the thermostat and thermostat housing (that includes temp sensors) about a year ago with OEM Motorcraft parts. I noticed the winter after that, that the...

'96 2.3L 2WD over 200k mi Never checked the actual radiator fluid except for when I bought the truck 2 months ago. I've always just looked at the resivour. About 3 weeks ago I noticed it was empty but that turned out to be the hose got disconnected rubbing against the air intake so I used a...

Hi all, I replaced my DPFE sensor a couple weeks ago. WOW! What a difference. Truck would not rev above 3200 or so. Now it will go up to 5k or so. Feels like a whole new vehicle. Friday I stumbled onto the throttle cable mod. Sure enough, even better! Can't believe how well it was running. So I...

Last friday my truck started steaming and loosing a lot of water through the tailpipe. Sucked 3/4 of my coolant out of my overflow tank in a 20 minuet drive. Its got 143,xxx miles. It burns about a quart every 3-4,000 miles. Did a compression test and got 120-115 psi over all 4 cylinders. my...

So the po of my truck really neglected the coolant system on my 1991 2.3L ranger. It has rust in the coolant still after 5 intense coolant changes, and I have replaced all the hoses, water pump (old ones fins rusted compleatly off) and thermostat last year when I did the last coolant change. It...

Hey guys, I don't post much here, but I'd greatly appreciate a little advice. I hope I posted this question in the correct subforum. I have a 1997 Ranger CrewCab 4x4 with the 4.0L V6 and an automatic trans. My problem is that I every time I open my hood, my coolant overflow bottle is bone dry...

So I just recently noticed something strange with my '97 Ford Ranger. While driving home from work on the highway the other day, my temp gauge needle rose all the way to the red and the warning Check Gauge light came on. The instant the light came on the gauge went back down to the normal...