ecgreen
Well-Known Member
- Joined
- Sep 21, 2018
- Messages
- 720
- Reaction score
- 287
- Points
- 63
- Location
- Dunbarton NH
- Vehicle Year
- 1989
- Make / Model
- Ford Bronco II
- Engine Type
- 2.9 V6
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- 3"
- Tire Size
- 33
Howdy ya'll! I am cleaning up the wiring on my 89 BII and I have a question. I swapped out my stock air box for an inline air filter that works better with my snorkel. On the stock air box there was some sort of ground plugged onto a nipple (hehe) on the air box lid. This wire joins another wire that has a plug (see picture) and both of these are spliced together and go into a grey connector (not shown). All of these are spliced to a wire that connects to a ground on the fender (to a bolt that holds the starter selonoid in). Whats the deal? I would like to simply cut out all the BS and run straight from that grey connector (which I assume goes to the ECU, but I dont know) to the chassis ground. Any help would be greatly appreciated. Awaiting knowledge drop...3...2...1...
Gratuitous Snorkel Pic:
Gratuitous Snorkel Pic: