Snoranger’s 2023 Ranger Lariat Tremor

[Uncle Gump]

That's slick too...

No way I give up those air vents... I'm sweating just thinking about it.

 

[sgtsandman]

That's slick too...

No way I give up those air vents... I'm sweating just thinking about it.

That was my reaction as well. I use those for heat also.

 

[snoranger]

Looks good. We need to do a write up on this for the Tech library

Done.

 

[snoranger]

I ordered a shower enclosure that will mount to the Prinsu rack awning brackets.

I also made some steel plates that will clamp between the bed rails and the Softopper. These will be the base for a custom bed rack to mount over the Softopper. The plan is to mount my RTT, a 270° awning, and a few other items that I’ll discuss when the time comes.

One final thing… I want to do a set of limb risers. I designed the front brackets to mount near the headlights, I just have to get a chance to build them. The upper end will attach to the roof rack. I have the cable, adjusters, etc. already, it shouldn’t take me long to throw it all together.

 

[snoranger]

I got time to install my new windshield banner.

A little advertisement for the site:

 

[snoranger]

 

[Blmpkn]

View attachment 100165

View attachment 100166

View attachment 100167

View attachment 100168

View attachment 100169

What's the wire for? The light on your cap?

 

[snoranger]

It’s the antenna for my GMRS radio. I still have to run the wiring for all the LED lights on the rack, but my time was limited today.

 

[Uncle Gump]

They make one of those filler panels for the older Rangers?

 

[snoranger]

They make one of those filler panels for the older Rangers?

Yeah… get one from a ‘99-‘16 f550.

 

[Uncle Gump]

Hmmm...

Assuming that's gonna be a dealer item.

 

[snoranger]

Hmmm...

Assuming that's gonna be a dealer item.

Mine came from Tasca Ford… it was only $10.

If you need it, I can look tomorrow and give you a VIN number of a truck that came with one. It may help them look it up.

 

[Uncle Gump]

Mine came from Tasca Ford… it was only $10.

If you need it, I can look tomorrow and give you a VIN number of a truck that came with one. It may help them look it up.

I found a part number... and found the part. It would be $22 shipped I think is what I saw. Not bad... and I may just buy one.

My plan A was to just take the light off... gut it... paint it... drill a couple holes.

Is that a two piece grommet you used?

 

[Uncle Gump]

And are you sure the full size truck part is going to fit my Ranger?

 

[snoranger]

This may be the part number.

Center High Mount Stop Light Bezel - Ford (F81Z-13A656-AA)