Momohenri
Member
- Joined
- Jan 19, 2017
- Messages
- 65
- Reaction score
- 3
- Points
- 8
- Location
- Hogne Belgium
- Vehicle Year
- 1988
- Make / Model
- Ford Bronco II
- Engine Type
- 2.9 V6
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
Hello, news from my Bronco2, I put a rinse aid in my A4LD Ford box, and redo a new oil change. It's going a little better but I always have a problem, when I start the engine cold, I have to wait 1 or even 2 minutes before having a good push then it goes well even with a trailer of 2000 lbs. Weird symptom, when cold I start the engine, shift all gears leaving ten seconds as recommended to take the level, and the level is too high (as when stopped) I let it run and once the oil is hot level is good. This box has two solenoids, could it come from this or the pump or something else