Welcome Visitor! Please take a few seconds and 10centguitar
Member
- Joined
- Aug 1, 2019
- Messages
- 10
- City
- Lubbock TX
- Vehicle Year
- 2001
- Engine
- 3.0 V6
- Transmission
- Manual
- Total Lift
- n/a
- Total Drop
- n/a
Hey yall,
Just wanted to share since all i do is read other peoples stuff on TRS.
I have been meaning to clean up the inside of my 01 ranger Cab for some time now.
Found a great steering wheel from an 06 ranger and some fresher looking seats from a 03 or 04 FX4 ranger at my local wrench a part. (id have to go back and check what year for the seats.)
I shampooed the seats and painted them with the fabric paint. Came out pretty good. Masking two-tone seats kind of sucked but all good in the end.
Used my seat belts and buckles. I had to bore out the holes where the buckle attaches to the new seats a hair to get them to fit. They are from different years.
This is a temp fit until I can pull some exact belts. I feel they are safe but I wouldn't pass the vehicle on like this.
I didn't get a pic of the after paint of the seats, was trying to beat the rain to get them in, but I got one of the trim pieces. All in all it looks great.
I really dig the newer steering wheel.
This project gave me the chance to detail the whole cab, which was covered in west texas dust.
Total cost was $175 and a good bunch of hours with a toothbrush.
The week after I got it all done, the slave cylinder went out. So i pulled the tranny out of the vehicle. I have convinced the wife that a 5.0 swap is in order. Im picking up a 2000 mounty with 113k and a blown tranny tomorrow.
Looking for my m5odr2 with 4wd now!
Just wanted to share since all i do is read other peoples stuff on TRS.
I have been meaning to clean up the inside of my 01 ranger Cab for some time now.
Found a great steering wheel from an 06 ranger and some fresher looking seats from a 03 or 04 FX4 ranger at my local wrench a part. (id have to go back and check what year for the seats.)
I shampooed the seats and painted them with the fabric paint. Came out pretty good. Masking two-tone seats kind of sucked but all good in the end.
Used my seat belts and buckles. I had to bore out the holes where the buckle attaches to the new seats a hair to get them to fit. They are from different years.
This is a temp fit until I can pull some exact belts. I feel they are safe but I wouldn't pass the vehicle on like this.
I didn't get a pic of the after paint of the seats, was trying to beat the rain to get them in, but I got one of the trim pieces. All in all it looks great.
I really dig the newer steering wheel.
This project gave me the chance to detail the whole cab, which was covered in west texas dust.
Total cost was $175 and a good bunch of hours with a toothbrush.
The week after I got it all done, the slave cylinder went out. So i pulled the tranny out of the vehicle. I have convinced the wife that a 5.0 swap is in order. Im picking up a 2000 mounty with 113k and a blown tranny tomorrow.
Looking for my m5odr2 with 4wd now!
