wider 35ttb setup

[509RANGER]

Where can I get my 35 cut and turned? I would lilke it to be made about 2" wider on each side.

 

[odie1969]

If you cut and turn it I beleive it will make it narrower than it is now, when you cut and turn you make the angle greater, so it actully lifts the truck four inches about, but you will need to get somebody to build you beams for you, and then get blonger springs and brakes lines, now if you only want a wider track, I would buy wheel spacers, and then I would get used to dooing wheel bearings, I personally will be doing a d44 to widen my track my that is about 1' wider than the standard.

 

[509RANGER]

Thanks, I have heard that people have widened their ttb's. So I thoght I would ask around, I also want to put 44 knuckles on my 35.

 

[CopyKat]

Camburg and solomotorsports can do. If your looking for wider and D44 knuckles why not Just go with a D44 conversion from autofab.

 

[509RANGER]

I will look into that thanks.

 

[4x4junkie]

I would do a D44 for sure. Cheaper than widening a 35, and you'll be able to replace most parts (the shafts in particular) with junkyard parts, should the need arise.

 

[hitech_hick]

I would do a D44 for sure. Cheaper than widening a 35, and you'll be able to replace most parts (the shafts in particular) with junkyard parts, should the need arise.

Not to mention that your bearings and ball joints will like you a whole lot better than if you were simply running wider rims.



hick