Trying to get replacement wheel studs that are 3 inches long, I can't find any that are the specific knurl diameter of 0.570 but I found ones that have a knurl diameter of 0.563 will these be to small of a knurl to press in will they be loose?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Wheel stud knurl size question
- Thread starter RedRanger2006
- Start date
Uncle Gump
Boomers gotta Boom
TRS Event Staff
TRS Forum Moderator
Supporting Member
VAGABOND
TRS Event Participant
GMRS Radio License
TRS 25th Anniversary
- Joined
- Sep 17, 2018
- Messages
- 16,096
- City
- Ottawa IL
- State - Country
- IL - USA
- Vehicle Year
- 1986
- Vehicle
- Ford Bronco II
- Drive
- 4WD
- Engine
- 2.9 V6
- Transmission
- Manual
- My credo
- Lead follow or get out of my way
Are you planning for wheel spacers that require longer studs?
Or some drag racing rule you need to meet?
Or some drag racing rule you need to meet?
For wheel spacers requiring longer studs
At this point I'm thinking I'll have to get the rotors machined for the old moroso studs I have in the other rotors to fit these 3 inch studs
Uncle Gump
Boomers gotta Boom
TRS Event Staff
TRS Forum Moderator
Supporting Member
VAGABOND
TRS Event Participant
GMRS Radio License
TRS 25th Anniversary
- Joined
- Sep 17, 2018
- Messages
- 16,096
- City
- Ottawa IL
- State - Country
- IL - USA
- Vehicle Year
- 1986
- Vehicle
- Ford Bronco II
- Drive
- 4WD
- Engine
- 2.9 V6
- Transmission
- Manual
- My credo
- Lead follow or get out of my way
Ya know... I just have a thing for wheel spacers. I just don't like them.
I converted to long wheel studs on a few different vehicles... to meet the rule book. I just picked studs that I could drill holes with a standard size drill bit and get .010 inch interference. I'm sorry I don't remember the size... but you what .010 inch interference.
I converted to long wheel studs on a few different vehicles... to meet the rule book. I just picked studs that I could drill holes with a standard size drill bit and get .010 inch interference. I'm sorry I don't remember the size... but you what .010 inch interference.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
