Beef52751
Well-Known Member
Do a 94 Explorer 8.8 and a 86 Ranger 7.5 use the same U-Joint???
Thanks
Thanks
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
U-Joints
- Thread starter Beef52751
- Start date
85_Ranger4x4
Wallows in rivers
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS 20th Anniversary
VAGABOND
TRS Event Participant
No, the the rear of the '86s is much smaller.
- Joined
- Aug 7, 2007
- Messages
- 2,384
- City
- Michigan
- Vehicle Year
- 1984, 1997
- Transmission
- Manual
- My credo
- If you're not making mistakes, you're not learning.
Nope. But the locating circle of the flanges should be the same. I redrilled my 8.8" axle flange with a smaller bolt circle in between the other holes so that it would fit the smaller (older) flange on the driveshaft side.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
