U-Joint Fit inside axle, good or bad???

[Blur2u]

So I am just going to peen the yokes, then I will put 4 tack welds on each cap and use what I have. I don't have the money to get new ones at this point. Maybe in a few months I can get the $$ to get some better shafts and get them ready for my next failure...but I have to get this rig back on the road so I can have some fun before winter....and fun during winter!

Everyone OK with this fix?

 

[compleckz]

mine egged out the first time i used 4wd after installing the 760x's and full-clips... almost all of the yokes are big enough to move the caps with my fingers.. i even broke the center slip yoke ears (was stuck, and reversing, cut the wheel a bit, my bad)...

so i should probably do the same thing as was described for Blur2u, huh?

 

[Todd]

BTW, I had a cap spit the clip and walk out of a FACTORY OE shaft & joint once. Its MORE than possible for them to spin and spit clips on perfectly good shafts under the stress that lockers put on them.

Ditto.