turn signals not working

[Wsljr2208]

about a week ago my turn signals just stopped working the hazard lights work now ive replaced the blinker/wiper arm on the steering column and the blinker relay under the dash is there any other parts that i could needlessly replace or am i just a lug nut

Sent from my S60 using Tapatalk

 

[Dirtman]

There is also a fuse. You didn't mention which year your truck is but some have seperate fuses for turn signal and hazzards. Not sure if you overlooked that. If the fuse is good, time to get the multi meter out!

Nevermind just saw your profile says it's an 04, should be a single fuse for turn and hazards so fuse can't be blown. Gotta be something relating to the switch connection/wiring if the hazards still work then.

 

[Wsljr2208]

There is also a fuse. You didn't mention which year your truck is but some have seperate fuses for turn signal and hazzards. Not sure if you overlooked that. If the fuse is good, time to get the multi meter out!

Nevermind just saw your profile says it's an 04, should be a single fuse for turn and hazards so fuse can't be blown. Gotta be something relating to the switch connection/wiring if the hazards still work then.

i apologise it is an 04 and i did replace the fuse even though it wasnt blown after several days of taking just about everything from the steering column to the turn signals apart i traced every wire with the multi meter and found that one of the wires had just barely pulled out of the pin connector that plugs into the switch om the steering column because of the tilt steering so plenty of foul launguge later i found the problem

Sent from my S60 using Tapatalk