AgPete139
09/2014 OTOTM Winner
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
OTOTM Winner
Solid Axle Swap
TRS Banner 2010-2011
TRS Banner 2012-2015
- Joined
- Aug 12, 2007
- Messages
- 2,866
- Points
- 3,101
- City
- Houston, TX
- Vehicle Year
- 1997
- Engine
- 4.0 V6
- Transmission
- Manual
- Total Lift
- ~9"
- Tire Size
- 35"x12.50"x17"
Alex & Craig, your hats have been Fedex'd and in transit. You should be receiving them in the next couple of days. They were shipped on Tuesday, February 7th.
Nitro, the hat should fit, and you would be at the upper limit of the medium. Everyone's heads are shaped differently. Some have said its perfect, while there have been a couple complaints that they are on the "shallow side." Do you think you have an longer (watermelon(?)) or taller head? It's elastic and cotton, so it can stretch and conform a little bit. I would gues "yes" it will fit you.
Dieseldane, if this is the case, then it will probably not fit you. However, I have sent you a PM. Check your Inbox.
I finally have 2 medium black hats left. Are you interested?
Mine is a 7 1/8th. Good on the medium or not??
Nitro, the hat should fit, and you would be at the upper limit of the medium. Everyone's heads are shaped differently. Some have said its perfect, while there have been a couple complaints that they are on the "shallow side." Do you think you have an longer (watermelon(?)) or taller head? It's elastic and cotton, so it can stretch and conform a little bit. I would gues "yes" it will fit you.
Just went and measured myself. 23 1/4 in, or 59 cm. That make me a medium according to your sizes? The hat I'm wearing now says XL, and it was kinda tight when I first got it...
Dieseldane, if this is the case, then it will probably not fit you. However, I have sent you a PM. Check your Inbox.
Got any hats left?
I finally have 2 medium black hats left. Are you interested?
Last edited: