booblinker
Well-Known Member
I need to replace my tensioner assembly because it is seized and the bearing in the pulley is bad. What tool do i need to get the bolt out, looked like it might be torx? I have a 93 ranger 3.0 with a/c
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
tensioner Assembly question
- Thread starter booblinker
- Start date
michowski
Well-Known Member
- Joined
- Aug 13, 2007
- Messages
- 1,166
Theres only a torx bolt holding the tensioner in and a pin that lines it up. First take the belt off. Then take the bolt out. Once done then you can just slide the tensioner off. Also I think there was washers on both sides of the tensioner but I cant really remember. Just take precaution and make sure to take note of how any washers go.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
