2.3L ('02-'11) swapping intakes on the 2.3 to get rid of swirl plates

[cozz]

well, sorry so long, I didn't end up getting the later manifold, but did end up removing the entire shaft and flaps. To seal the holes between the runners, I used a high heat epoxy....as for the flap controller, I just hooked it back up and let it think it was still working. No problems

 

[cozz]

I still think the later manifold would work....same engine...If I end up keeping this truck long enough, I will probably have to test my theory one day

 

[pjtoledo]

I still think the later manifold would work....same engine...If I end up keeping this truck long enough, I will probably have to test my theory one day

on my 2005 I replaced the engine with a 2002. swapped all the 2005 exterior accessories including the intake.
my 2005 never had swirl plates, so no issue for me.