Swapping 95 ranger 4.0 with 86 bronco 2 2.9

[sclark]

I need a wiring diagram for this

 

[franklin2]

Can you make the title more clear? It sounds like you are putting a 86 2.9 into a 95 ranger that had a 4.0. That is a rare occurrence if you are.

 

[lil_Blue_Ford]

A 95 is going to have OBD II and you are going to have to swap the entire electrical system because nothing will match most likely.

 

[sclark]

Putting the 95 4.0 ranger motor in the 2.9 bronco 2. I was just trying to find the diagram for this. I didn't realize I had to switch everything til after I started

 

[franklin2]

Here is some reading for you.

4.0 Liter Engine Conversion FAQ's - The Ranger Station

Are you looking to replace the 4-cylinder, 2.8, 2.9 or 3.0 engine in your Ford Ranger with a 4.0 liter? This page is a good starting point.

www.therangerstation.com

Ford 4.0L V-6 Conversion - The Ranger Station

Are you doing a Ford 4.0L V-6 Conversion on your older Ford Ranger. It's a common upgrade on the 2.8 & 2.9 Ford Rangers.

www.therangerstation.com

4.0 Liter Conversion On Older V-6 Fords - The Ranger Station

Introduction: My name is Steve Butler (DieHardFord in TRS Forums) and I am very into Fords. I have a 1972 F-250, a 1980 Bronco, and a 1985 Bronco II, all of which I pretty much put together myself. This page … Continued

www.therangerstation.com

Ford 4.0 Liter V-6 Conversion Wiring (From Explorer to Bronco II) - The Ranger Station

One of the challenges to converting from a Ford 2.9 to a Ford 4.0 is the wiring harness. Here's how to use the harness.

www.therangerstation.com

https://www.therangerstation.com/tech/wiring-a-4-0l-to-an-original-1983-1988-dash/#gsc.tab=0