ranger bed floor and BII floor

[swamprat]

Does anybody know if the floor out of a ranger bed(89) will fit in place of a 89BII floor? My 1989 BroncoII floor in the cargo area is rusted through along the back by the hatch and mostly across behind where the rear seats used to be. I was thinking about cutting the floor out of the cargo and rear seat area and replacing it with a piece cut out of the foor of a ranger truck bed. If we can graph a tailgate on the back end of a BII then the diminsions should be close. Cutting it along the seams on the floor wouldnt be hard. I could make the cargo area floor one level since I dont have rear seats in it anyways. Just need to weld a vertical section in the front. One set of body mounts will have to be modified. Would it be worth it?