• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

radio station pre-set wont work


Boggin

Well-Known Member
Joined
Nov 3, 2007
Messages
5,711
Transmission
Manual
i can set the pre-sets to a certain station while the truck is running. but if i shut her off for a few mins then start her up again, the presets will be erased. maybe once or twice i started up the truck right after i shut it off and they were still there. anybody know what this problem is? is it in the stereo itself?
and its the factory am/fm/tape radio.
 
Will your dome lights and stuff work with the truck off? It sounds like for some reason your stereo is losing it's always on 12V power source when the truck is shut off.

Might pull the stereo out and probe the wire for 12V hot to make sure it stays live when the key is turned off.
 
yup everything else works fine. and thank you, i might pull the radio and check those wires, but i might just live with it until i get a new system put in her.
thanks again
 
Maybe check your manual about it and see if anything like that is mentioned.
 
Is it an aftermarket stereo? Did you install it yourself?

If someone else installed it, they probably screwed up with the constant power to the unit, and instead only ran power through the ignition or something.
 
Sorry missed that part...

Must be bad wiring. Has it always had this problem?
 

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top