Focklerx33
Well-Known Member
will a front drive shaft out of a 94 ranger 4.0 work in my 96 3.0 i'm talking about the drive shaft coming from the transfer case to the front diff
Last edited:
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
quick question.
- Thread starter Focklerx33
- Start date
Focklerx33
Well-Known Member
1994 Ford Ranger 4X4 Front Drive Shaft . 16 spline, surface rust, in good usable condition.
28 3/4 inches from end of spline to end of H Yoke.
28 3/4 inches from end of spline to end of H Yoke.
adsm08
Senior Master Grease Monkey
Supporting Member
Article Contributor
Ford Technician
TRS 20th Anniversary
- Joined
- Sep 20, 2009
- Messages
- 34,623
- City
- Dillsburg PA
- Vehicle Year
- 1987
- Engine
- 4.0 V6
- Transmission
- Manual
- Tire Size
- 31X10.50X15
Should. Same front axle, same trans, same t-case. Should.
Hopman
Well-Known Member
Just because it SHOULD fit does not nessesarily mean it WILL.
Focklerx33
Well-Known Member
thanks guys
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
