I have a 94 Ranger and I am planning on using the Skyjacker CL II 6" Lift, my question is do I need different drive shafts of will the stock ones work. I already know about swapping to the one piece for the rear. Just want to know if the stock lenghts work.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
question about driveshafts
- Thread starter explorerhavok
- Start date
The ones you have will work just fine, but will that amount of lift, you will likely feel some vibrations from the rear driveline when starting from a stop. Even moving the carrier bearing mount an inch lower can greatly reduce this.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
