Power seat installation.

[koda6966]

I picked up some power seats from an 01+ Explorer, they will bolt in fine but the drivers side is a power seat.

Can I just take the connector and wire to ground and hot and have it work right? Or do the wires go elsewhere? I have both the seat side connector and the truck side connector.

The vehicle they are going in is my 1993 Xcab.

 

[85_Ranger4x4]

All you need is a hot and a ground.

If I remember right they are hot all the time originally.

 

[koda6966]

Alright, cool beans. Too bad the plugs not already there lol.

I'll have to pick up a fuse holder then. My auxiliary fuse block sucks.

 

[bilzy7]

Koda if it works good could you take some pics? Bout to try and get an exp to molest would love to see pics!!

 

[85_Ranger4x4]

Koda if it works good could you take some pics? Bout to try and get an exp to molest would love to see pics!!

Dunno what you have, but Explorer tracks are supposed to be a bolt in for an extended cab.

 

[bilzy7]

I used mountaineer seats and ya they are pretty much direct bolt in, I was referring to what he is going to do for the cables. Plenty of threads posts about people having power seats, but no photos and no how to's. I will post a how to.. I am not trying to thread jack I'm just lost on this.
Cant someone just splice the wires into seat belt sensor? Or that thick berry bush of cables under carpeting.

 

[koda6966]

Yeah I'll snap pics, it's nothing special I didn't even run the wiring good I just put it under my floor mat lol. It was only one wire anyway.