Poor Man's full floater 9"

[AaronC]

Ok, I picked up a 9" out of a full size Bronco. I was originally planning on doing a gear swap and converting to disc brakes..

Then I thought to myself.. It would be nice to have a full floater..

But lets face it, spending 2000 on hubs, axles and brakes is out of the question..

I started looking into a "poor man" setup.. Which uses D44 snouts on the outside of a 9" housing. Anyone done it? I need help.. I know Dutchman will make an axle set for cheap..

Whats the spline on D44 outers? anyone know the shaft diameter?

 

[AaronC]

Poor Mans Full Floater article...
Link to a Full floater kit...

 

[chrwilkins30]

seems good. but just to clarify how much is $2350.00 Canadian dollars in regular money from AMERICA.

 

[AaronC]

seems good. but just to clarify how much is $2350.00 Canadian dollars in regular money from AMERICA.

Its 2381 or something like that...

 

[chrwilkins30]

not sure if thats good or not. its alot of money for sure. whats the rate of a full float 14bolt all built up to the same or better then the 9in.