dahunter_2007
Well-Known Member
I was wondering if anyone could tell my how a would go about polishing the intake manifold on my 94 4.0 OHV. Any advise would be greatly appreciated. THANKS!!
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
polishing intake manifold
- Thread starter dahunter_2007
- Start date
dremel or die grinder. you can use the stone attachments or sanding drums. Flapper wheel for the final finish. You typically don't want to go too smooth with the intake (at least near the heads) since you want to induce some tumble in the air so the fuel will mix better.
get a gasket and match the ports to help minimize pumping losses.
get a gasket and match the ports to help minimize pumping losses.
JohnPi
Well-Known Member
Were you looking for external or internal polishing?
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
