newbie

[19954.0beater]

was up everyone? I have a couple of questions you might be able to help with. first i am making my own leafspring mounts(so i only ned to do it on time) but both mine are broken so i cannot get good mesuments, specs on hole spacing,and width from top hole to middle holes and to bottom center hole. second question, 1995 ranger with 4r44e trans. 4.0L, will a 5r55e work and would i get 5 speeds? wht mods whould be needed to make that work if any? trans is on its way out and want to relace with newer preferably auto 5speed.

 

[bigblue88]

junkyard or dealership if you have to and measure it, not sure bout the trans

 

[ranger_mclaren]

Welcome to the forums, yes swaping out to a 5R55E will give you a 5-speed auto. I'm not completly sure but it should be a direct bolt on. You may to need to swap out computers so it reads correctly. Ask your question in the tranny tech section, here:

http://www.therangerstation.com/forums/forumdisplay.php?f=13

Sorry I couln't help ya out better. Again welcome.