Need your help again

[SouthernRanger]

I'm trying to change the flywheel on my 2.3. I think I have all the bell housing bolts out, but I can't get the trans to seperate from the engine. I know both the top bolts are out and I've check both sides and believe they're all out. I've tried putting a jack and a block of wood under the oil pan. I've been under that truck shaking, jerking and pulling that trans every which a way but still nothing. What gives.

 

[mn_smokeater]

double check the bolts they should be all the way out, then the only thing holding it togeather should be the lil pins used to guide it so its correct?