Welcome Visitor! Please take a few seconds and bigdan002001
Well-Known Member
Hey guys, I am tearing apart the front end on my 97 Ranger with the Dana 35 front axle, and the previous owner has cut the nut from the bottom of the pinch bolt. So it's just dangling around in there, but still cannot get it past the radius arm, but will cut the head of the bolt to get it out. I need to know what length of all thread to buy and what size/thread pitch to buy. I read on here somewhere that a member did this and thought it was a good way of fixing this problem. Just he didn't give the lenght of the all thread. Since my bolt is already cut and partially gone, i cannot measure it to find out. If i recall the all thread was like M10 or M12 x 1.75 or something like that, but if someone could elaborate a little better I would appreciate it. Thanks,
BigDan
BigDan
