need some advise

[drover_brad]

is it possible to fit a 1992 f150 5.0 efi engine into a bronco 2, or will the intake manifold hit the hood. the reason i ask is that i have never seen it done only 5.0l mustang. Plz help Thx

 

[BronKitis]

is it possible to fit a 1992 f150 5.0 efi engine into a bronco 2, or will the intake manifold hit the hood. the reason i ask is that i have never seen it done only 5.0l mustang. Plz help Thx

Do you ask because you have access to one out of an F150? I believe even if it is too high you can interchange the manifolds.

 

[drover_brad]

yes i have one that was just rebuilt

 

[adsm08]

I'm not sure about the difference in height, I think they are the same. I do know that the upper intakes are interchangeable though. The lower ones are the same.

Go ahead and put it in, and if you can't get the hood down with the truck intake, go get a car intake.

 

[Robert_1967]

or you could trim the hood just enough to make it fit, would look like some out of this world supercharger, or something.



Robert.

 

[fireexploder93]

yeah when in doubt, plazma cutter

 

[drover_brad]

the thing i found online is that the fuel delivery is different between a mustang and a f-150 such as fuel pressure, and injectors.

 

[adsm08]

Probably true, they are meant for different stuff so they will be tuned differently. The manifolds should be roughly the same though. Go with the truck stuff since you have a truck.