Need hp with m 2.3 turbo swap

[94 b3000 turbo]

Hi guys I'm kinda new to this websitemail but I'm looking for some help! so here's the rundown I have a 1994 Mazda b3000 that I have slowly been tearing apart and I plan on doing a 2.3 turbo swap pretty much got everything I need but I'm at a standstill went to install the motor mounts and I do not believe I have the right ones I'm trying to figure out which motor mounts I need to properly swap my 3.0 rth thw 2.3.f anybody could give me some advice and maybe send some pictures that would be amazing! Thanks guys

 

[Mark_88]

Hi and welcome to TRS~!

There is a Forced Induction forum that would be better suited for this question and I have tagged your post for the moderators to move it for you.

http://www.therangerstation.com/forums/forumdisplay.php?f=44

There may be a few on here that visit this section that could help you, but there is more specific information about turbo swaps that you can read as needed...

Enjoy and hope your build goes well...

 

[scotts90ranger]

You will need the frame side mounts for a 2.3L to get the engine bolted to the engine crossmember, There are 4x2 and 4x4 specific brackets (since the engine crossmember is different between 4x2 and 4x4) and I believe '87-97 brackets will work