Need a quick measurement

[dr.dirty]

Hey guys I havent been here in a while but need some quick help.


If anyone has a soft tonneau cover I need the measurements of the frame itself. Im building and offroad trailer and I am going to use a Ranger soft cover for the lid. I need to make sure I make the box the correct width and length.


thank you!


It needs to be for a 6 ft fleet side box.

 

[Bronco638]

It's easy to measure without the tonneau frame.

Front-to-Rear: the inside measurement, of the frame, will be from the tailgate to the bulkhead. Hold the measuring tape to the inside of the bulkhead and measure to the inside edge of the tailgate. The frame's inside edges sit directly above the bulkhead's and tailgate's inside edges.

For side-to-side measurement, just measure from inside edge to inside edge and then add 1". My frame sits, on the bed's sides, about 1/2" outboard of the bed's inside edge.

Does that help?

 

[dr.dirty]

It's easy to measure without the tonneau frame.

Front-to-Rear: the inside measurement, of the frame, will be from the tailgate to the bulkhead. Hold the measuring tape to the inside of the bulkhead and measure to the inside edge of the tailgate. The frame's inside edges sit directly above the bulkhead's and tailgate's inside edges.

For side-to-side measurement, just measure from inside edge to inside edge and then add 1". My frame sits, on the bed's sides, about 1/2" outboard of the bed's inside edge.

Does that help?

It would but currently I don't have a ranger to measure off of.

 

[Bronco638]

Ah, poor assumption on my part. Let me measure for you tonight.

 

[Bronco638]

70.5" front-to-rear, 58" side-to-side.