Welcome Visitor! Please take a few seconds and 
- Joined
- Aug 30, 2007
- Messages
- 2,439
- Age
- 38
- City
- Cass Co, Missouri
- Vehicle Year
- 1994
- Transmission
- Manual
I have a 78'' Bronco 9" that I'm having cut to 59'' wms-wms. I'm having my pinion offset 1.75" to the right, just like the stock 8.8, so my driveshaft clears my tank skidplate and muffler.
Long story shortened'
I was gunna have it cut to EB dimensions so that I could buy shafts if I had to, but if I snap 31spl shafts I've got more important issues than gettin a new one. Also all the EB shafts aren't set for wide brakes... just a PITA.
Anyways, where should I get shafts from? I'm 99% sure mine can't be resplined because of the taper. I was told over a year ago, that one of the manufactures had shafts that were splined from the tip to about 10"(?) from the flange, anyone know of those? I looked on Moser, Strange, and Superior's websites to no avail.
Any incite to my situation would be greatly appreciated. This is the first narrowed rear I've ever dealt with. Thank you ahead of time.
Long story shortened'
I was gunna have it cut to EB dimensions so that I could buy shafts if I had to, but if I snap 31spl shafts I've got more important issues than gettin a new one. Also all the EB shafts aren't set for wide brakes... just a PITA.
Anyways, where should I get shafts from? I'm 99% sure mine can't be resplined because of the taper. I was told over a year ago, that one of the manufactures had shafts that were splined from the tip to about 10"(?) from the flange, anyone know of those? I looked on Moser, Strange, and Superior's websites to no avail.
Any incite to my situation would be greatly appreciated. This is the first narrowed rear I've ever dealt with. Thank you ahead of time.
