89bronco93
New Member
- Joined
- Dec 5, 2010
- Messages
- 2
- Vehicle Year
- 89
- Transmission
- Manual
i have a 89 ford bronco II and the gas gauge is broke...any suggestions?
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
my gas gauge is broke...
- Thread starter 89bronco93
- Start date
n_grimm
Well-Known Member
- Joined
- Oct 27, 2010
- Messages
- 152
- Vehicle Year
- 1988
- Transmission
- Automatic
A lot of us have found the brass sending unit's float to have holes in it for various reasons. Mine had about 10 holes corroded thru it due to sitting for a while. It's a lot easier to get to if you cut an access hole above the tank but of course there are risks involved. If you ground the wire from sending unit to the gauge,(Haynes manual says yellow/white) it should go to full. If so, problem is most likely the sending unit or the float.
Last edited:
89bronco93
New Member
- Joined
- Dec 5, 2010
- Messages
- 2
- Vehicle Year
- 89
- Transmission
- Manual
ok that actually makes a lot of sense. ill try it.
Sponsored Ad
Sponsored Ad
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
Ranger Adventure Video
TRS Merchandise
Follow TRS On Instagram
