Motor Mounts

[bergilong]

I want to put a 5.0 into my '94 ranger 2wd. Will these mounts work? http://www.jegs.com/i/Trans-Dapt/969/9736/10002/-1 These are the only mounts I could find but they say 83-87 ranger.

 

[ATX]

For my 94 swap I used the stock 4.0 mounts and explorer 5.0 plates flipped side for side plates wise . I went this route since mounts are easily replaceable with over the counter parts .

I have since changed the passenger side mount to a 85 bronco mount and custom mount bracket on the frame .sliding is pretty hard on thAt one mount I found out .

Sent from my iPhone using Tapatalk

 

[bergilong]

I should probably also mention that I have a 2.3.

 

[ATX]

Well don't know if the mounting locations are the same on the frame
Between 4 and 6 bangers . But I'm pretty sure the holes are there and just not used . So with that you could probably still buy the 4.0 mounts cheap at autozone or wherever and get the block to mounts plates


Sent from my iPhone using Tapatalk

 

[BlackBII]

The crossmember has the holes for the 2.3 and the 4.0 mounts, so you should be good.